FLOAT-OFF Boat Lifts is one of the newest boat lifts to come onto the boating market. The FLOAT-OFF Boat Lift was shown at the 2005 MIAMI BOAT SHOW and has received acknowledgements from the boating community. The FLOAT-OFF Boat Lifts are represented and sold by TMP MARINE PRODUCTS and are available for vessels up to 16,000 lbs.
|
|
|
The FLOAT-OFF Boat Lifts innovative design, provides a smooth,safe and simple lifting and launching operation for your boat. The FLOAT-OFF Boat Lifts are 100% fiber plastic, which means no rust or electrolysis of any kind. Even the bolts are manufactured of a fiberglass composite. Generally, No Special Permitting or Permanent Installations is required.
However - always check with your local government agencies for regulations and requirements for your area.
|
|
|
The FLOAT-OFF Boat Lift, with it's clean lines, fine fiberglass composite construction and sleek look, will add to the appearance of your waterfront property.
|
|
|
|
| |
The FLOAT-OFF Boat Lift Model 30 / 30 Standard Features include the following items:
|
|
|
| |
|
|
| |
- All Fiber Plastic construction
- Fiberglass composite bolts
- (2) Boat Rests with neoprene pads
- (6) Fiberglass cleats
- (1) Control Box with 15 ft. of hose and connectors
- (1) 4 HP blower with GFCI connector
- (4) Fixed PVC boat guides
- (2) Boat positioning lines and bungee cords
- Diamond pattern Non-skid deck
- Reinforced frames and boat rest
|
OPTIONS:
Automatic PVC boat
Double Braided mooring
Control Box cover |
|
|
|
|
|
|
All fiberglass cleats
|
Diamond pattern
non-skid deck
|
Reinforced frame
& boat supports
|
|
|
|
|
| |
| The FLOAT-OFF Boat Lifts are available in 5 Models for boats up to 16,000 lbs. The FLOAT-OFF Boat Lift uses the same framework for all models and adds additional flotation chambers to increase the buoyancy. |
| |
30 / 30 A Boats to 5,500 lbs.
30 / 30 B Boats 5,500 lbs. to 7,500 lbs.
30 / 30 C Boats 7,500 lbs. to 10,000 lbs.
30 / 30 D Boats 10,000 lbs. to 12,000 lbs.
30 / 30 E Boats 12,000 lbs. to 16,000 lbs.
|
|
|
|
| |
FLOAT-OFF Boat Lifts make raising and lowering your boat, out of the water, a very simple process. The FLOAT-OFF Boat Lift will raise the boat high enough for the lower unit / outboards to be out of the water. This will prevent any growth from getting onto you boat and motor and keep your efficiency high. No growth, No Slime, No Dirty Bottoms.
FLOAT-OFF Boat Lifts are a submersible boat lift that uses two air-filled pontoons for flotation. There are openings, on the bottom of the pontoons, that allow water to enter and exit. This operation is very smooth and simple.
|
|
|
| |
|
|
| |
| |
TO LAUNCH YOUR BOAT:
- Open the (2) safety valves at the lift
- Open the Launch Valve at the control box (pontoons begin to fill with water)
- Once the boat begins to float, close the launch valve and you are done
- Drive your boat off
|
|
|
| |
TO LIFT YOUR BOAT:
- Drive your boat onto the lift
- Tie off your boat at the pre-determined location and attach the bungee tension cords
- Exit all passengers
- Launch Valve, at the control box, should be closed
- Turn on the Air Pump (110v) to displace the water from inside the pontoons.
- As the boat rises, use the leveling valve (if necessary) for Port and Starboard balance
- Once air is noticed exiting from the rear of the lift, turn the air pump off
- For safety - Close the (2) safety valves, at the lift, once you are done for the day.
- Full operation takes approximately 7 minutes
|
|
|
|
|
|
| |
|
|
|
| PONTOON DIMENSIONS
LENGTH: 30 ft.
WIDTH: 30 inches
HEIGHT AT CENTER: 6 ft.
|
OVERALL DIMENSIONS
Pontoon Length: 30 ft.
Width Outside Pontoons: 15 ft. to 17 ft.*
* Depending on Inside Pontoon Width
Width Inside Pontoons: From 10 ft. to 12 ft.
|
| BOAT SUPPORTS
LENGTH: 10 ft. to 12 ft.*
* Depending on Inside Width Ordered
WIDTH: 23 inches
SPACING: 10 ft. Apart
|
FLOAT-OFF SPECIFICATIONS
WEIGHT: 4,000 lbs
DRAFT:
WITHOUT BOAT 13 INCHES
WITH BOAT - for each 1000 lbs. PLUS 1-1/8"
|
|
|
|
|
| |
Below are photos of the Boat Supports used on the FLOAT-OFF Boat Lifts. They are well made and have neoprene pads at the support points, to protect your boat and the lift.
|
|
|
|
|
|
Float-Off Boat Supports
|
Bow Support
|
Stern Support
|
|
|
|
|
| |
FLOAT-OFF Boat Lifts are very easy to install.
1. The FLOAT-OFF Boat Lift will be brought to your site, either by Common Carrier, Flat-Bed, or on the company trailer,depending on where you are located (Photo # A).
2. The FLOAT-OFF Boat Lift will either be brought to your site and off-loaded there, or brought to a ramp and then towed to your berthing space (Photo # B).
3. Once at the site, the FLOAT-OFF Boat Lift is secured in place with dock lines (Photo # C).
|
|
Photo # A
|
Photo # B
|
Photo # C
|
|
|
|
 |
|
| |
| Look over the FLOAT-OFF Boat Lift literature and then call / fax / E-mail TMP Marine Products with your specifications, needs and requirements. If there is additional information that you need, regarding the FLOAT-OFF Boat Lift contact us and we will get that material forwarded to you. We would also appreciate the opportunity to present to you, a No Obligation price quotation for your FLOAT-OFF Boat Lift. We look forward to hearing from you and helping you "Lift Your Bottom Out of the Water". |
|
|
|
|
|
Call or E-mail for current prices
|
